temperature and melt
pressure of the polymer were able to be directly obtained through temperature/pressure sensors.
The pattern in a barrier screw is much less distinct due to the mechanical separation of the solid and melt
by the barrier flight.
* Hot melt
adhesive coating is the responsibility of AACC.
Other factors, such as size of the reverb/pot, temperature and length of holding, may affect this comparison, but considering holding the melt
versus shutting it down could reveal a possibility for significant savings.
On the lower end a melt
drop is created by means of induction heating, into which inoculation single crystal is introduced, which is attached to the lower rod, and then melt
zone is created.
Least Cost Suitable Charge (LCSC)--An electric arc furnace formula to determine what to use in any given melt
based on current prices and suitable chemical composition.
As the snow melted
in the spring and more vegetation became exposed, the albedos of all the test sites dropped to their summertime values, between 11 and 19 percent.
The chocolate kisses should melt
in your hand, because chocolate's melting point is lower than the average human body temperature: 37[degrees]C (98.6[degrees]F),
East and West, and North and South, the palm and the pine, the pole and the equator, the crescent and the cross - how the great Alchemist melts
and fuses them with his purifying flame!
Most use small amounts of casein, a milk protein, to help them melt
(although White Wave Soya Melt
Fat-Free, despite its name, didn't).
For the aforementioned slip mechanisms, the flow was considered to be continuous at the bulk polymer melt/interfacial polymer melt
* SPX series pressure transmitters for hazardous or explosive areas, including fiber spinning and melt
This fifth tenant, melt
quality, is firmly in the control of the casting facility.
where [F.sub.d] and [F.sub.p] are drag and pressure flow shape factors to correct for the fact that more polymer melt
will flow through a channel which is almost full than one which is completely full and D = barrel diameter; N = screw speed in RPMs; h = screw channel depth; p = number of flights; b = flight width; t = flight lead length; [phi] = helix angle of screw flights; [L.sub.m] = effective length of melt
conveying section; and [mu] = melt