According to the general requirements, a stack of crushed cars loaded
on a flatbed should require no more than three tie-downs with an aggregate WLL of at least 6,000 pounds.
From the desktop computer, create a CD for each folder that is being loaded
to the MSD.
Indentors of cone, sphere and flat sphere shapes were loaded
at axial force into a representative rubber material (NR with sulfur cure system and carbon black fillers) and turned 200[degrees] against it at room temperature (RT).
Transporters with the Rhine River Detachment loaded
equipment in barges at Bamberg, Aschaffenburg and Mannheim during the last two weeks of January.
This paper describes the behavior and failure modes of joints loaded
with dynamic forces that simulate hurricane wind and impact loads on residential structures.
Thousands of other financial centers and corporations were shut down or severely slowed as the virus spread world-wide, many sites losing millions of dollars as thousands of networks and applications were loaded
beyond their limits.
This results in an emergency panel being loaded
with noncritical equipment for which emergency power generation during an outage is unnecessary.
Vacuum chamber can be loaded
by a timing cycle, which is easily adjusted at the control panel, or by an end point-control sensor mounted to the vacuum chamber.
In accordance with the stow plan and unique ship characteristics, we loaded
all light vehicles and personnel carriers with the heavier pieces being loaded
at the end.
Belts are typically designed based on a 100% rated tension which is the maximum load the belt is expected to see during its normal fully loaded
The acquiring bank settles loaded
funds with the card issuing bank daily.
Walker estimates that around 1,500 tons of cargo can be loaded
onto a river barge, far more than can be loaded
on a truck or a gondola car, meaning that moving ferrous scrap by barge is less expensive on a per-ton basis.
dual-column models of 1000 to 5000 lb cost $19,000 to $36,000.
Since the construction began on the fleet in the mid-1990s, Chambers figures the 841st has loaded
or unloaded as many as 30.
The spool must be grasped in such a manner that the steel cord is not damaged, and such that either end of the spool may be selectively loaded
onto the spindle.