lap joint

(redirected from lap joints)
Also found in: Dictionary, Encyclopedia.
Graphic Thesaurus  🔍
Display ON
Animation ON
Legend
Synonym
Antonym
Related
  • noun

Synonyms for lap joint

joint made by overlapping two ends and joining them together

Synonyms

Related Words

References in periodicals archive ?
Strictly ornamental, the straight, regular stretchers were fastened with inset lap joints where undersides of ends of stretchers are notched out to fit into slots milled and chiseled into inside edges of posts.
The compatibility of treated wood veneers with PVC was examined by measuring the shear strength of a single lap joint. The measured shear strengths are compared, together with the surface tensions for the untreated and treated wood veneers and PVC in Table 2.
With notched rafters set temporarily on ends, locate and mark end braces for lap joints.
Ojalvo and Eidinoff [7] presented results of an analytical investigation on the influence of bond thickness upon the stress distribution in single adhesive lap joints. The work extended the basic approach for bonded joints, originally introduced by Goland and Reissner, through the use of a more complete shear-strain/displacement equation for the adhesive layer.
Cut lap joints by making multiple cuts with a circular saw, then cleaning out the waste with a sharp chisel.
In most simple mechanical assembly applications, cost-effective joints such as Lap joints are desirable and used.
Two gates have lap joints, cut with dado blades, to increase the bonded surface areas and provide added stiffness.
Especially single lap joints are the most preferred joint model due to ease of use.
We debated how to access components, how to disassemble things with only a few tools, how to minimize or eliminate niche points or lap joints, and what level of polish to make the food contact surfaces.
Test methods for wood adhesives for non-structural applications: Determination of tensile bonding strength of lap joints. EN 205.
Replacing conventional cores with printed cores eliminated the need for lap joints, pasting, core seams, and brought the reduction of core-on-core generation of sand particulate.
thermal cycling, analysis of separate, sequential and concurrent EM and thermal cycling (TC) was imposed on single shear lap joints, and the microstructure and crystal orientations were incrementally characterized using electron backscatter diffraction (EBSD) mapping.
In welded lap joints and cover plates, both mode I and mode II stresses are singular at the weld root, where fatigue cracks are likely to initiate.
In the second run, single lap joints were produced, after laser treatment, to measure the effect of the treatments on the adhesive strength.