grooved


Also found in: Dictionary, Medical, Idioms, Encyclopedia.
Graphic Thesaurus  🔍
Display ON
Animation ON
Legend
Synonym
Antonym
Related
  • adj

Synonyms for grooved

Synonyms for grooved

established as if settled into a groove or rut

References in periodicals archive ?
In the extrusion of SSE with grooved feeding zone, it was generally found that the melting quality was poor and the extrusion was not stable because the melting efficiency of the melting zone did not match the delivery efficiency of the feeding zone.
Pressures exceeding 12,000 psi have been achieved at the end of the grooved section, so care must be exercised in design to prevent over-pressurization of the barrel.
The ability to make grooved trouser test specimens went through a development process.
Grooved piping systems offer advantages in laying pipework cross-country that can make them a superior choice to traditional joining techniques.
Victaulic, the world's largest manufacturer of mechanical pipe joining systems, said consultants and the contractor chose its grooved products when faced with what it said was an exceptionally large install and a very tight time frame.
Besides being notable structures, they all make use of grooved piping instead of welded piping.
The grooved drums skimmed up to three times as much oil as the smooth drums did, the researchers report online for an upcoming Environmental Science & Technology.
There are a number of reasons why suction rolls are sometimes grooved. Grooving provides knuckles of high pressure, thought to aid in the transfer of water from the sheet to the felt under the action of the pressure in the nip.
Traditional grooved pins could not solve the problem, as the peaks would shear off during installation.
"But no other theropod is known to have had a grooved, smooth-edged tooth like this." Meat-eating dino teeth usually feature serrated or jagged edges.
The grooved feed-section temperature should be raised to 210 F, just below the melting point of the LLDPE.
It is the usage of the grooved feed section that most influences the efficiency of the extrusion process.
Grooved rolls and grooved Vacrolls complete the sheet stabilization requirements of the Uni-Run sections.
Most popular grooved patterns can be accurately reproduced, and lineal grooving speeds to 40 inches per minute are possible, ac-cording to the literature.