chamfer


Also found in: Dictionary, Medical, Legal, Acronyms, Encyclopedia, Wikipedia.
Graphic Thesaurus  🔍
Display ON
Animation ON
Legend
Synonym
Antonym
Related
  • all
  • noun
  • verb

Synonyms for chamfer

two surfaces meeting at an angle different from 90 degrees

Synonyms

Related Words

cut a bevel on

Synonyms

Related Words

cut a furrow into a columns

Synonyms

Related Words

References in periodicals archive ?
5 for cutting steel with thickness 15 mm it is obvious that the chamfer when cutting with DWJ technology is significantly lower than with AWJ technology.
As the instantaneous position of gear engagement ring teeth chamfer and shifter sleeve chamfer is indeterminate, hence analyzing double bump is a bit complex issue.
Researchers have also evaluated changes in the marginal fit that may occur during various stages of fabrication.24 Euan et al25 found that during different stages of fabrication, differences in marginal fit were observed in the chamfer group (p=0.0042) but there were no differences in the crowns with shoulder margins (p=0.4335).
Except with the chamfer strip, each piece should be the same thickness so successive layers have a uniformly flat base.
In looking at my gun, it seemed to me the factory chamfer was really nothing more than a quick rounding-off of things, perhaps done automatically.
If you need only chase the inner chamfer on an existing crown just to make sure it is square, there are a couple of tools available.
Mainly five margin designs are used: shoulderless, chamfer, shoulder, sloped shoulder and shoulder with bevel.
Three metal dies with a total convergence of 5-degrees and different margin designs (0.5-mm light chamfer, 1.0-mm deep chamfer, and 1.0-mm shoulder) were prepared.
introduces the C-Cutter Mini, an ultra-high-feed chamfer mill.
Ninety percent of the time you'll find a simple round-over, beading, rabbet or chamfer bit grasped tightly in the jaws of my router.
Hircis is also expected to cut the time required to perform chamfer measuring, which usually involves coating the chamfer with a silicone rubber compound and comparing a cross section of the cured impression to a drawing of the machined part.
The D4580 chamfer body from Walter USA (walter-tools.com/us) permits drilling and chamfering with a single tool, thereby reducing overall machining time and costs.
Brownells' revolver chamfering sets allow us to chamfer chambers and optimize or restore forcing cones.