carriage bolt

(redirected from carriage bolts)
Also found in: Dictionary, Encyclopedia.
Graphic Thesaurus  🔍
Display ON
Animation ON
Legend
Synonym
Antonym
Related
  • noun

Words related to carriage bolt

a roundheaded bolt for timber

Related Words

References in periodicals archive ?
The posts need to have the thread corresponding to the thread on the carriage bolts. I use bolts with 10-24 thread.
4' x B' x 3/4" BC sanded plywood 2 2' x 4' x 1/2" hardwood plywood 1 1x6 x 6' pine 1 2x4 x 8' pressure-treated lumber 1 1x2 x 4' oak 1 1-1/4" x 16" oak dowel 1 1-1/2" screws (small box) 1 3" trim head screws (small box) 1 1-1/2" 18-gauge brads (small box) 1 1/4" x 3-1/2" carriage bolts 8 1/4" nut and washer 8 Wood filler, patch or putty 1 Paint, quart 1 Polyurethane, quart 1 Cutting List (for one unit) 3/4" BC SANDED PLYWOOD KEY QTY.
This rivet head is made from the head of a 1/4" carriage bolt. A hole is just drilled in the receiver and the rivet is set in place followed by spot welding from the back side.
"The crib has about $800 worth of carriage bolts and lag screws in it."
* Carriage Bolts have a square shoulder under the head that pulls into soft materials such as wood and prevents the bolt from turning while the nut is being tightened.
Most conventional snowplow systems use a long steel backer with three sections of steel together with carbide inserts that are held together with carriage bolts.
Carriage Bolts. Carriage bolts are large-diameter bolts with a rounded head used for connecting structural pieces.
Two legs will also need holes, so the two cutting boards can be fastened together with the help of wing nuts and carriage bolts. To do this, follow Drawing 2 and drill 9/32" holes where indicated.
Attach the bottom 60-inch 2-by-6 crosspieces 12 inches from the bottoms of the posts with countersunk 5 1/2-inch carriage bolts, and use 7-inch carriage bolts to hold a pair of 2-by-6 crosspieoes at midlevel (42 1/2 inches above the bottom crosspieces), sandwiching the posts.
Among the choices are nails, wood screws, lag screws, carriage bolts, an array of premanufactured fasteners, and specialty connectors (Figure 7-3).
Alignment is controlled with springs and wing nuts on 1/4-inch carriage bolts. Because this mirror-box design is so compact, the primary mirror is relatively exposed and unprotected.
Then used carriage bolts to mount the L-shaped pieces into the Versa Track running along the gunwales and drilled three holes in the bottoms for mounting them to the boat.