Other shoppers watched in disbelief as the hoodlum, puffing on a cigarette, stuffed the razor-sharp blade back
in his coat, pocketed his loot and casually wandered out of the store.
He noticed the same thing that Peter Kostis and Gary McCord noticed a month ago, that I was taking the blade back
too far inside.
Holding the blade flat as shown in the first picture of step 3, push the blade back
and forth across the coarse side of the stone, exerting even pressure through the stroke.
As the crank was turned, the entire side of the case and the drum inside rotated, pulling the blade back
into the case for storage.
To maintain those angles, companies sell guides you can clamp on knives, or have stones with angles built in to set your blade back
onto before you sweep over the stone.
If you're using the glass and sandpaper method of sharpening (Tip 10), press the back side of the blade against the sandpaper and move the blade back
and forth, being careful to hold it perfectly flat.
Prosecutor Simon Duncan told Liverpool crown court: "The defendant grinned and put the blade back
in his pocket.
8, by formation of artificial roughness on the blade surface in the bladed disks, it is partially possible to affect the characteristics of the axial compressor, especially the pressure increase ratio: [MATHEMATICAL EXPRESSION NOT REPRODUCIBLE IN ASCII] the inlet area blade back
roughness of the bladed disk is distributed along the entire blade height, which leads to a shift in pressure lines downwards at all frequencies of rotor rotation, and the range of the non-separated flow about the stage expands: the limit of rotational stall shifts towards lower air flow rate.
He is psyching himself out of it with his interminable check-and-recheck preamble before actually pulling the blade back
and last week's missed cut with rounds of 76-73 have not exactly put him spot-on for this.
The ES881 uses a newly developed linear-drive electromagnetic system, which uses magnetic attraction and repulsion to move the blade back
and forth in a linear motion.
He would stand over a putt and seemed unable to draw the blade back