The highlights of fiber orientations in the xy plane
are given in Fig.
On Z axis, there will be displaced two sliding elements: a superior one above the XY plane
and an inferior one, below this plane, each element being equipped with a machine-tool shaft, preferential is a milling shaft.
The simulated antenna radiation patterns in both YZ plane ([phi] = 90[degrees]) and XY plane
([theta] = 90[degrees]) at different frequencies of 90, 92, 94, and 96 GHz are shown in Figures 4(a) and 4(b), respectively.
The projection of the three circles onto XY plane
is shown in Fig.
For this purpose, we let the direction of incidence wave be in the xy plane
, with the angle of incidence with respect to the x-axis being 1, 2, 5, 10, 15, and 20 degree, respectively.
In addition, the Ca[Cl.sub.2]-EDC group extends the least (3.7% in XY plane
and 3.5% in Z axis), while the EDC group shows the largest extension (35.9% in XY plane
and 32.7% in Z axis).
In the end face images are aligned in xy plane
using the ICS based alignment approach (section 3.1.5).
3, we have calculated the electric field distributions of four absorption points (520 nm, 700 nm, 965 nm, and 1770 nm), including a cross-sectional (xy plane
) and overhead view (xz plane).
The temperature distribution at steady state along the XY plane
of the installation is shown in Figure 4 for the different cases.
* "3DSP Feature Generation in the YZ and XY Plane
In a full cycle, wave diffraction's angle is from -90[degrees] to -84[degrees] in the XY plane
, of which frequency ranges from 0.21 Hz to 1.42 Hz.
Figure 7(a) is an illustration of the location of target, focal plane, and detected plane in xy plane
. Figures 7(b)-7(e) are the original fluorescent images for concentrations of 4, 6, 8, and 10 [micro]mol/L normalized with the maximum of (e) while Figures 7(f)-7(i) are the corresponding restored images normalized with the maximum of (i).