roughness


Also found in: Dictionary, Medical, Legal, Acronyms, Idioms, Encyclopedia, Wikipedia.
Graphic Thesaurus  🔍
Display ON
Animation ON
Legend
Synonym
Antonym
Related
  • noun

Synonyms for roughness

Synonyms for roughness

the quality of being unpleasant (harsh or rough or grating) to the senses

an unpolished unrefined quality

Synonyms

Related Words

used of the sea during inclement or stormy weather

Related Words

rowdy behavior

the formation of small pits in a surface as a consequence of corrosion

harsh or severe speech or behavior

Related Words

References in classic literature ?
The way they looked at her made her uncomfortable, she knew not why; while there was an uncouthness and roughness about them that did not please her.
This was Princess Myakaya, noted for her simplicity and the roughness of her manners, and nicknamed enfant terrible.
The roughness sensor enables a new, simpler workflow in quality assurance and is particularly suitable for the quality inspection of powertrain components.
In order to determine the influence of tool roughness on metal plastic flow in the forward microextrusion process conducted in dry conditions, the toolkit author's copyright project was designed and manufactured [6].
The surface roughness height is commonly used to quantify the surface quality of a machined wood-based composite part.
The highlight values have shown that the value of the surface roughness is the lowest.
Field testing compared the road roughness measured by the connected vehicle method and the strain-based method.
The partnership will develop a broad range of AFM metrology solutions for process development, production, and failure analysis, including the most accurate surface roughness measurement with wafer mapping and incoming material monitoring.
In paper (10) two modelling approaches, regression and Artificial Neural Network (ANN) are applied to predict minimum surface roughness in the end milling machining process.
The roughness in contact surface between the top surface of the workpiece and plate of testing machine is other considered parameter.
The machining method could turn the tool surface unsuitable for coating and lead to unsatisfactory adhesion or surface roughness with insufficient lubrication properties [10,11].
One of the measurements we use for comparing different incoming copper surfaces prior to final finishing is RSAR, or roughness surface area ratio.
Research led by the Department of Geology at the University of Leicester, eveals that there is a close match between roughness of teeth and diet, with teeth from animals that eat hard foods having rougher surfaces than those that eat soft foods.
also optimized the effect of cutting parameters on surface roughness using genetic algorithms in the tangential turn-milling method.
In lotal, eight surface conditions were evaluated; these conditions involved the use of a standard stainless steel (STAVAX, HRc53; UDDEHOLM KK) mirrored surface, three stainless steel mirrored surfaces with various coatings, and four stainless steel surfaces with different degrees of nonspecular roughness (see Table 1).