The quantities of Hg(II) sorbed and desorbed
were determined at the termination of each cycle for three repeated cycles (Table-4).
At the 30% ethanol, the total flavonoids were hardly desorbed
x] will be desorbed
, thus clearing storage sites that will be available for N[O.
The same was found for the water desorbed
from the grains, wherein the temperature increased the drying time and accelerated the process .
Although there is a difference in higher temperature desorption behavior of DP600, no difference in the amount of diffusible hydrogen, desorbed
at lower temperatures, is observed.
water ensured better hydration in internally cured samples than control samples and produced concrete with better performance.
Where qde is the quantity desorbed
by each of the eluent and qad is the quantity adsorbed by the adsorbent during loading.
In addition, previously adsorbed Ni(II) onto DTOF and SDTOF resins could be easily desorbed
by EDTA and HN[O.
These are desorbed
to atmosphere during the pressure swing cycle, leaving a supply of ultra-pure nitrogen.
As the eluents flow thoroughly into the dried silica gel, the bio-active constituents in the CLCE that have been absorbed in the silica gel were desorbed
into the eluents (the desorption process is based on the similarity of eluents polarity).
The metal ion loaded adsorbent was most effectively desorbed
by using 0.
Adsorption/desorption trials showed that Cr(VI) can be effectively desorbed
from the fungal biomass using nitric acid.
Since the TiO2 photocatalyst was weakly bound to the surface of the zeolite, TiO2 photocatalysts could be desorbed
from the surface of the zeolite by a simple agitation of the slurry solution.
That molecule can then be desorbed
by applying a reverse potential.
However, the physisorbed molecules are very weakly bound to the surface, which can be easily desorbed
by solvent rinse or heating under a lower temperature (45) (such as below 110[degrees]C reported by Chandekar et al.