carriage bolt


Also found in: Dictionary, Encyclopedia, Wikipedia.
Graphic Thesaurus  🔍
Display ON
Animation ON
Legend
Synonym
Antonym
Related
  • noun

Words related to carriage bolt

a roundheaded bolt for timber

Related Words

References in periodicals archive ?
Carriage Bolts have a square shoulder under the head that pulls into soft materials such as wood and prevents the bolt from turning while the nut is being tightened.
The carriage bolt was lengthened and covered with a protective rubber hose.
1-5 gallon, (or 3-1/2 or even 2-1/2 gallon) plastic bucket 1-15" x 15" piece of 3/8 or 1/2" plywood (seat) 1-3" long, 3/8" carriage bolt 1-3/8" nut 2-large washers (2" to 2-1/2" in diameter) 9-medium-sized washers (about 1-1/4" in diameter) 1-boat cushion (optional)
Install and tighten a 1/4-inch-diameterby-4-inch carriage bolt in each of the holes, then climb a stepladder to take a sighting along the tops of all the hoops.
Install and tighten a quarter-inch-diameter-by-4-inch carriage bolt in each of the holes, then climb a stepladder to take a sighting along the tops of all the hoops.
When you've got everything right, remove one nail from a single corner joint, drill a bolt hole right through and then install a carriage bolt.
But don't overtighten--that can pull the carriage bolt heads right through the door skin or strip the lag screw holes.
Replace the slide and install the sixth carriage bolt on the right end.
Tenders are invited for Marine hardware: Follansbee (or equal) hot dipped galvanized (HDG) Carriage bolt set includes, bold, nut and flat washer all HDG.
Be sure to place a nut on the bolt before sticking it through the hole, and then one after so that the carriage bolt may be adjusted up or down and then tightened in place.
Insert and tighten a 3/8" x 3 5/8" galvanized carriage bolt with large flat washers behind nut.
The bracket involves pre-drilled holes for grounding lugs to minimize installation time, and a carriage bolt for increased stability.
Now fit this assembly between the main uprights and slip a 4 1/2" carriage bolt through at the bottom of the spanners.