Loosen the bolt until the threads come out of the end baffle
, then you can separate the rest of the stack from the through-bolt and the stainless steel front cap.
Our Tavola baffles
ceiling system has a robust, attractive appearance.
and sleeve design are figure-8 shaped, which explains why the ISB's appearance is reminiscent of an over/under shotgun.
Peng et al  studied experimentally shell and tube heat exchanger with continuous helical baffle
and compared the result with the segmental baffle
shell and tube heat exchanger and they found that the use of continuous helical baffles
resulted in nearly 10% increase in heat transfer coefficient for the same pressure drop.
Other authors studied the effects of some geometrical parameters of baffles
such us (number, width, length and distance between the lower edge of the baffle
and the bottom of the vessel) on the heat transfer coefficient in an agitated tank by a RT (Rushton Turbine), PBT (Pitched Blade Turbine) and a propeller .
SONEX PLANO Absorbers feature factory-cut, T-slots along the top of baffle
Besides, the effect of the baffle
is clearly observed in this figure as at each specified reaction time, the distribution curve measured for the reactor without baffles
was wider than that for the reactor with baffles
Sui Northern Gas Pipeline Limited (SNGPL), in its efforts to serve its consumers better and reduce their gas bills in winters, has developed a conical baffle
to be inserted in fuel gas pipe of geysers, which reduce the gas consumption upto 25%.
The next element is rotated 90 degrees about the central axis with respect to the previous baffle
set, so on and so forth.
positioning is essential in dissipating the kinetic energy of incoming flow and reducing chances for occurrence of short circuits .
Acoustically, a baffle
is defined as any object that restrains or cancels the sound in specific directions.
Siemon has introduced SidePOD and Baffle
solution designed to support side-to-side ventilated active equipment and end of row (EoR) configurations in data center applications.
Each heat pipe has an evaporator section and a condenser section that are separated by a permanent baffle
so as to provide a closed loop.
The last, front baffle
is also 7075 aluminum, but while it has notches, it lacks the teeth out front.
I suggest you check the ridge from the outside with binoculars to see if it has an external baffle
to deflect the wind over it.